36 PTO
PTO
PTO OPERATION
To avoid personal injury:
A Disengage PTO, stop engine, and allow all
rotating components to come to a complete
stop before connecting, disconnecting,
adjusting, or cleaning any PTO driven
equipment.
BPTO Clutch Control Lever
The PTO clutch control lever engages or disengages the
PTO clutch which gives the PTO independent control.
Shift the lever to "ON" to engage the PTO clutch. Shift the
lever to "OFF" to disengage the PTO clutch.
A To avoid shock loads to the PTO, reduce engine
speed when engaging the PTO, then open the throttle
to the recommended speed.
A To avoid damage of PTO clutch and implement, shift
the PTO clutch control lever slowly, when engaging
the PTO clutch. Do not keep the PTO clutch control
lever half way.
Proper warm up is strongly recommended in cold
weather.
Do not continuously shift the PTO clutch control lever.
A Tractor engine will not start if PTO clutch control lever
is in the engaged "ON" position.
A If the PTO system is engaged and you stand up from
the seat, the warning buzzer will whistle for about 10
seconds after standing up.
This is because the tractor is equipped with "Operator
Presence Control System".
BPTO Gear Shift Lever
To avoid personal injury:
A Be sure to observe the PTO shaft speed
prescribed for the individual implements. It is
extremely dangerous to run an implement at
high speed that is meant to be operated at low
speed. Use only when this higher rpm is
specifically recommended by the implement
manufacturer.
The PTO gear shift lever can be set to either 540 rpm or
540E rpm positions.
Move this lever to either position with the PTO clutch
control lever set to "OFF".
A When light load, select the "540E" position for
economical operation.
(1) PTO clutch control lever "ON" "OFF"
(1) PTO gear shift lever (A) 540 rpm
(B) 540E rpm
(N) "NEUTRAL POSITION"
To Next Page
Loading...
Need help?
General
