OPERATING THE VEHICLE26
ENGLISH
BHazard Light Switch
Press the hazard light switch, the hazard light flash along
with the indicator on the instrument panel.
Press the hazard light switch again to turn off the hazard
light.
A The hazard light switch is operative when the key
switch is in either the "ON" or "OFF" position.
Be careful that leaving the switch "ON" causes the
battery to run out.
BTurn Signal Light Switch
To indicate a right turn, turn the turn signal light switch
clockwise.
To indicate a left turn, turn the turn signal light switch
counter-clockwise.
The corresponding right and left turn signal lights and
indicator on the instrument panel will flash.
A The turn signal light switch is only operative when the
key switch is in the "ON" position.
A If the hazard light switch is pressed to the "ON"
position while the turn signal is activated, all the lamps
flash.
A Be sure to return switch to center position after turning.
C Trailer Indicator
When you use the turn signal light switch with the trailer
power connector connected, the indicator in the
instrument panel start flashing.
A If the indicators in the instrument panel starts fast
flashing, it means the front or rear turn signal light bulb
may be broken. Check the bulbs.
[RTV-X900KR]
(1) Turn signal light switch (A) "RIGHT TURN"
(B) "LEFT TURN"
(1) Trailer indicator
(1) Head light
(2) Hazard / Turn signal light
(3) Tail lamp (Combination lamp)
(4) Number plate lamp
To Next Page
Loading...
Need help?
General
