OPERATING THE VEHICLE40
ENGLISH
BDriving through Water
To avoid serious injury:
A Do not drive through water whenever it is
possible.
A Drive slowly across shallow water and choose
a location to enter and exit the water where the
banks are not too steep or slippery.
A Before entering water, check for rocks, holes or
other obstacles that may cause overturn, stuck
or submerged.
A Never operate the vehicle in the fast flowing
water or in water deeper than the bottom edge
of the axle caps.
A Do not enter and drive through water over 10 km/h.
Critical damage may occur in the engine, if the speed
is over 10 km/h.
OPERATING HAND THROTTLE
[if equipped]
A Pull the hand throttle while pushing the button, and the
engine speed increases.
A Push the hand throttle while pushing the button, and
the engine speed decreases.
A Fine-tune engine speed by turning the hand throttle.
A Do not use the hand throttle while driving the vehicle,
always push the hand throttle back to the "LOW"
position.
Before driving the vehicle, confirm the hand throttle to
be positioned to the "LOW".
STATIONARY HYDRAULIC OUTLET
[if equipped]
To use the hydraulic outlet system, start the hydraulic
outlet system in the following steps.
1. Apply the parking brake and place chocks at the tires.
2. Make sure the shift levers are in "NEUTRAL", and start
the engine.
3. Operate the hydraulic outlet lever.
(See "HYDRAULIC OUTLET" in "HYDRAULIC
OUTLET" section.)
4. Set the engine speed to provide recommended fluid
rate. (Refer to the implement operator's manual.)
A Do not use a hydraulic implement which has a
hydraulic motor except those approved by Kubota.
(1) Axle cap
(1) Hand throttle (if equipped)
(2) Button
(A) "PUSH"
"HIGH"
"LOW"
To Next Page
Loading...
Need help?
General
