Kubota Z482-E - Stopping the Engine; Checks During Operation; Radiator Cooling Water( Coolant); Oil Pressure Lamp

6 OPERATING TH E ENGINE
STOPPING THE ENGINE
1. Return the speed co n trol lever to low Idle,
and run the engine under idling
2. Set the engine stop lever to "STOP"
posit i on .
3. With th e starter sw it ch placed at "OFF"
position , remove the key .(Be sure to
return the stop l ever as it was after
stopping the engine, and get re ady for the
next starting.)
(1) Speed control lever (A) "IDLING"
(2) Engine stop lever (B) "OPERATION"
(C) "START"
(D) "STOP"
CHECKS DURING OPERATION
While running, make the following checks to see that all
parts work well.
•Radiator Cooling water(Coolant)
AwARNING
To avoid personal injury:
• Do not remove radiator cap until cool ant
temperature is well below its bo iling point.
Then l oosen cap slightly to the stop position, to
relieve any pressure, before removing cap
comp le tely .
When the engine overheats and hot coolant overflows
through the radiator and hoses, stop the engine
immediately and make the following checks to determine
the cause of trouble:
Check Item
1. Check to see if there Is any water leak;
2. Check to see if there Is any obstacle around the
cooling air inlet or outlet;
3. Check to see if there is any dirt or dust between
radiator fin and tube;
4. Check to see if the fan belt is too loose;
5. Check to see if radiator water pipe is clogged;
6. Check to see if anti-freeze is mixed into coolant in
warm seasons.
•Oil pressure lamp
The lamp lights up to warn the operator that the engine oil
pressure has dropped below the prescribed level. If this
should happen during operation or should not go off even
after th e engine is accelerated more than 1000rpm,
immediately stop the engine and check the following:
1. Engine oil level (See "ENGINE OIL" in Maintenance
Section).
2. Lubricant system (See "ENGINE OIL" in Maintenance
Section).