MAINTENANCE
Engine oil inspection
● Start engine and keep idling for a few minutes.
● Stop the engine and stand the scooter on level
ground by main stand.
● Wait a while, remove the oil level dipstick.
● Wipe oil off, then reinsert the oil level dipstick
without screwing in.
● Remove the oil level dipstick. The oil level should
be between the high and low lines on the dipstick.
● If required, add the specified oil so the oil level
reaches the high level line on the dipstick. Do not
overfill.
● Reinstall the oil level dipstick. Check for oil leaks.
WARNING
The eng ine and rel ated parts can
become very hot. Be careful when
inspecting the oil level so not to suffer
burns. Make the engine and exhaust
system cool down before inspection.
Engine oil replacement
Engine oil quality is the major factor that affects
engine life. Change your scooter's engine oil
as specified in the maintenance schedule.
● Warm engine up thoroughly then stop.
● Stand vehicle by using the main stand.
● Place an oil container beneath the drain hole.
● Remove the oil level dipstick.
● Remove the drain bolt and drain off thoroughly
● Tighten the drain bolt to the specified torque.
● Add oil to reach the high line on the dipstick.
● Screw the oil level dipstick into place securely.
Tightening torque
Engine oil drain bolt: 25N·m (2.5kg·m, 18ft·lb)
CAUTION
Use the genuine engine oil or another with
the same quality and grade to avoid
burnout on the engine parts.
50
To Next Page
Loading...
Need help?
General
