2
19
HOWTOADJUSTCLOCK
Multifunction display - Digital clock
The clock indicates the time in hours and minutes
when the ignition is “ON The clock display also
indicates .
”.
To adjust the clock’s time manually,
follow this procedure:
Turn the ignition switch “ON
Press and hold the ADJUST button for more
than two seconds to select the ODO mode.
”
NOTE: The digital clock can be only adjusted
in ODO mode, don’t select the tripmeter or oil
service meter mode if you want to adjust the
time on the clock.
1.
2.
Press and hold both the Mode button and Adjust
button at the same time for more than two seconds.
The “hour” digits will be begin flashing, indicating the
clock time can be adjusted.
3.
To set the hour display, press the ADJUST button
until it displays the correct “hour” time
4.
To change the minute display, press the MODE
button until the “minute” digits begin flashing
5.
To set the minute display, press the ADJUST
button until it displays the correct “minute” time
6.
To end the clock adjustment, press both the
MODE and ADJUST buttons at the same time.
The display will stop flashing automatically. The
adjustment will be cancelled if any button is not
pressed within approximately ten seconds
7.
To Next Page
Loading...
Need help?
General
