43
6 Commissioning
6.5 Settings
According to which access level you are located, you can make various settings. In access
level 2 (Service), all settings can be made.
6.5.1 Maintenance Mode
In SETTINGS select (see Chapter 6.3.2 Activate/deactivate Maintenance Mode.)
6.5.2 Filter Time
In the MAIN MENU, select to make set-
tings.
SETTINGS, offers the following setting pos-
sibilities:
Maintenance mode (Level 0); see Chap-
ter
6.5.1 Maintenance Mode
Filter time of the measured values
(Level 0).
Analogue outputs (Level 1); see
Chapter 5 Display and Operational Con-
trols
Probe replacement (level 1).
CO
e
response threshold (Level 2).
Display (Level 0).
Limit values (Level 1).
Digital outputs (Level 2).
Filter time of the measured values:
No access level is required to make this set-
ting.
Time over which the measured values are
determined
(in an integrated manner).
Factory setting:
O
2
measured value 2 seconds
CO
e
measured value 10 seconds
To Next Page
Loading...
Need help?
General
