5
1 Important Information about the Manual
1 Important Information about the Manual
1.1 Validity of these Instructions
This manual describe the Lambda Transmitter LT3-F with all required components. The infor-
mation in this document applies to the software version 1.0.0.0. If you utilise a different ver-
sion, this can lead to other effects to your device than those described in this manual.
The CO/O
2
control described in this document must be activated in the burner control units
stated above and the required measurement equipment must be connected.
The basic documentation to this commissioning supplement is:
• Manual of BurnerTronic BT300, BT320 ... BT340 (publication no. DLT1201)
• Manual of Lambda Transmitter LT3-F KS1D (publication no. DLT3140)
The lambda transmitter LT3-F must be operated with the CO/O
2
control option.
For this purpose, the following LAMTEC burner control systems can be used:
• BT300
• ETAMATIC/ETAMATIC S
• ETAMATIC OEM/ETAMATIC S OEM
• ETAMATIC V/ETAMATIC VS
• FMS
• VMS
The description of the CO/O
2
control can be found in the following documents:
• Commissioning supplement for the CO/O
2
control in connection with BT300 (publication
no. DLT1209)
• Commissioning supplement for the CO/O
2
control in connection with FMS/VMS/ETAMA-
TIC (publication no. DLT5015)
NOTICE
The current publications are available for download from the LAMTEC Website,
www.lamtec.de.
To Next Page
Loading...
Need help?
General
