ClampMeter XPClampMeter XP
1. 2. 3.
2
TO AVOID ELECTRICAL SHOCK,
REMOVE ALL TEST LEADS
BEFORE OPENING THE CASE
OR BATTERY DOOR. DO NOT
OPERATE WITH BATTERY
DOOR OPEN.
WARNING
!
ClampMeter XP
Rev17W46
A quality product from
GmbH & Co. KG
Donnerfeld 2, 59757 Arnsberg
Germany, Tel.: +49 2932 638-300
Fax -333, www.laserliner.com
The “ ” symbol is not shown when auto power-off is deactivated. Auto power-off is reset by switching
off the measuring device.
„APO d“ appears
on the LC display
Press and hold MODE button while at the same
time turning the rotary switch to the required position
Rotary switch
set to „OFF“
Attaching the test prods
To avoid the risk of injury, the test prods must
always be kept in the holder at the rear of the
device with the protective caps fitted when not
in use and during transportation.
Insertion of batteries
Open the battery compartment (10) and insert
batteries according to the symbols. Be sure to pay
attention to polarity.
1
AUTO OFF function
In order to preserve the batteries, the meter switches off automatically if it is left idle for 30 minutes.
Deactivation of AUTO-OFF function
Current AC/DC 1000A AC/DC
Voltage AC/DC 1000V AC/DC
Frequency, continuity, resistance,
diode test, continuity, capacitance
600V AC/DC
Temperature (°C/°F) 600V AC/DC
Maximum limit values
19
EN
To Next Page
Loading...
Need help?
General
