14
2 sec
2x
1x
2 sec 2 sec
1x
Switch signal tone on/off:
device on tone on tone off
Important notices
– The laser points to the location that will be measured.
No objects may get into the laser‘s line of measurement.
– The device compensates the measurement for different room
temperatures. Therefore allow the device a brief adaptation period
when changing locations with large temperature differences.
– The device is only conditionally useable in outdoor areas and
cannot be used in strong sunlight.
– The measurement results of outdoor measurements may be
influenced or falsified by rain, fog and snow.
– Carpeting, upholstery or curtains will not reflect the laser optimally.
Measure to flat surfaces.
– Measurements made through glass (window panes) can falsify
measurement results.
– An energy-saving function switches the device off automatically.
– The batteries must be replaced when the battery symbol (a) starts
to flash.
Continuous measurement / min/max values:
device on activate start stop
A signal sounds at 1 second interval during the measurement.
The LC display shows the max value, the min value and
the current value. The max value is required to determine
diagonals while the min value is used to determine verticals
and horizontals.
!
GB
To Next Page
Loading...
Need help?
General
