Launch Creader Professional 909X User Manual

15
LAUNCH Professional 909X User Manual
Misre Monitor
(Type 2)
Continuous 1 1 1
3 - similar
conditions
80
Fuel System
Monitor
Continuous 1 1 or 2 1
3 - similar
conditions
80
Catalytic
Converter
Monitor
Once per trip 1 2 1 3 trips 40
O
2
Sensor
Monitor
Once per trip 1 2 1 3 trips 40
O
2
Sensor
Heater Monitor
Once per trip 1 2 1 3 trips 40
EGR Monitor Once per trip 1 2 1 3 trips 40
EVAP system
Monitor
Once per trip 1 2 1 3 trips 40
Secondary Air
System
Monitor
Once per trip 1 2 1 3 trips 40
2.7 DTCs and MIL Status
When the vehicle’s on-board computer detects a failure in an emissions-related
component or system, the computer’s internal diagnostic program assigns a
diagnostic trouble code (DTC) that points to the system (and subsystem) where
the fault was found. The diagnostic program saves the code in the computer’s
memory. It records a “Freeze Frame” of conditions present when the fault was
found, and lights the Malfunction Indicator Lamp (MIL). Some faults require
detection for two trips in a row before the MIL is turned on.
Note: The “Malfunction Indicator Lamp” (MIL) is the accepted term used
to describe the lamp on the dashboard that lights to warn the driver that an
emissions-related fault has been found. Some manufacturers may still call
this lamp a “Check Engine” or “Service Engine Soon” light.
There are two types of DTCs used for emissions-related faults: Type “A” and
Type “B.” Type “A” codes are “One-Trip” codes; Type “B” DTCs are usually Two-

Launch Creader Professional 909X Specifications

General

Brand	Launch
Model	Creader Professional 909X
Category	Diagnostic Equipment
Language	English