41
ranty shall also be considered null and void if the
user is not able to produce an original (legible and
complete) document proving purchase or if it not
possible to read the appliance serial number located
on the frame. The appliance shall not be replaced
and the warranty shall not be extended once the ap-
pliance has been aected by a fault. Repairs shall be
carried out at one of our Authorised technical Service
Centres or at our factory. Appliances for repair must
be sent carriage free, that is, the user shall pay and be
responsible for carriage. The warranty does not cover
the cleaning of working parts, any scheduled main-
tenance nor the repair or replacement of parts sub-
ject to normal wear and tear. The manufacturer shall
not be held liable for damage to persons or things
caused by any installation which does not comply
with the instructions in the manual or faulty use of
the appliance.
10.1. SCRAPPING OF THE MACHINE
If the machine will no longer be used, remove the
batteries and dispose of them in accordance with
the eco-compatibility regulations as set forth in Eu-
ropean standard 2013/56/EU or deposit them in an
authorised collection centre.
To dispose of the machine, comply with the current
laws where it is used:
ERROR DESCRIPTION LED SIGNAL TYPE
I2T BRUSHES Brush motor overcurrent Brushes (E33)
Flashes slowly (every 800
mS)
BRUSH SHUTDOWN
Brush motor short circuit
(current peak above the limits
permitted by the card)
Brushes (E33)
Alternates between
two quick flashes and
1-second pause
I2T SUCTION Suction motor overcurrent Suction (E34)
Flashes slowly (every 800
mS)
SUCTION SHUTDOWN
Suction motor short circuit
(current peak above the limits
permitted by the card)
Suction (E34)
Alternates between
two quick flashes and
1-second pause
MAXIMUM TEMPERATURE
The card temperature exceeds
the maximum value of 80°C
Brushes and
Suction (E33, E34)
Flash quickly
BATTERY IS CHARGING
The card has detected that the
battery charger is connected
Yellow (E38)
Flashes every second for
400 mS, then average
speed
START WITH OPERATOR
PRESENCE
The card has been started with
the operator presence lever
enabled
Yellow (E38)
Flashes every second for
100 mS, then high speed
MAXIMUM BATTERY
The card has detected that
the battery value exceeds the
maximum permitted value
Yellow (E38)
Alternates between
five quick flashes and
1-second pause
10. CONDITIONS OF WARRANTY
All our appliances are subjected to rigorous tests and
are covered by warranty against material or manu-
facturing defects for a period of 12 months. The war-
ranty comes into eect from the date of purchase.
The date of purchase is the date indicated on the
receipt issued by the Reseller when the appliance is
consigned. The manufacturer shall repair or replace
any faulty parts free of charge during the period cov-
ered by the warranty. Any defects, which cannot be
clearly attributed to material or manufacturing de-
fects shall be examined by one of our Technical Ser-
vice Centres or at our factory and charged in accord-
ance with the outcome. The following are anyhow
not covered by the warranty: accidental damage dur-
ing transportation or handling, accidental damage
caused by negligence or unsuitable conduct, dam-
age due to incorrect or improper uses or installations
which do not conform with the warnings included in
the instruction manual, and anyhow due to unusual
events which do not depend on the running or use
of the appliance. Appliances requiring repair must
be delivered at the Technical Service Centre com-
plete with all their original accessories together with
proof of purchase. If the appliance has been repaired
or tampered with by unauthorised third parties, the
warranty shall be considered null and void. The war-
To Next Page
Loading...
Need help?
General
