BALTIC R410A-IOM-0708-E Page 27
STARTING THE UNIT
At this point the unit circuit breakers should be open
You will need a DS50 maintenance controller or Climalook
with appropriate Interface.
Fig. 30
The jumpers are factory set and the configuration switches
are adjusted depending on the option the type of unit.
Connecting the CLIMATIC displays
Fig. 31
Close the 24V Control Circuit breakers.
Fig. 32
The CLIMATIC 50 starts after 30s
Reset the DAD photo (If fitted)
Fig. 33
Check and adjust the control settings.
Refer to the control section in this manual to adjust the
different parameters
To Next Page
Loading...
Need help?
General
