Lennox LNIV2610 User Manual

10 11
Dehumidifying operation
Ensure the unit is plugged in and power is on. The
OPERATION indicator on the display panel of the indoor unit
starts fl ashing.
1. Press the MODE button to select DRY mode.
2. Press the UP/DOWN buttons to set the desired
temperature. The temperature can be set within a range
of 17ºC~ 30ºC in 1ºC increments.
3. Press the ON/OFF button to start the air conditioner.
NOTE:
In the Dehumidifying mode, you cannot change the fan
speed. It has already been automatically controlled.
Adjusting air fl ow direction
Use the SWING and DIRECT button to adjust the desired
airfl ow direction.
1. When pressing the DIRECT button, the horizontal louvre
changes 6 degree in angle for each press.
2. When pressing the SWING button, the louvre will swing
up and down automatically.
NOTE:
When the louvre swings or moves to a position which would
affect the cooling or heating effect of the air conditioner, it
will automatically change the swing/moving direction.
HOW TO USE THE BUTTONS HOW TO USE THE BUTTONS
Auto operation
Ensure the unit is plugged in and power is on. The
OPERATION indicator on the display panel of the indoor unit
starts fl ashing.
1. Press the MODE button to select Auto.
2. Press the UP/DOWN button to set the desired
temperature. The temperature can be set within a range
of 17ºC~ 30ºC in 1ºC increments.
3. Press the ON/OFF button to start the air conditioner.
NOTE:
1. In the Auto mode, the air conditioner can logically choose
the mode of Cooling, Fan, and Heating by sensing the
difference between the actual ambient room temperature
and the setting temperature on the remote controller.
2. In the Auto mode, you cannot change the fan speed. It
has already been automatically controlled.
3. If the Auto mode is not comfortable, the desired mode
can be selected manually.
Cooling /Heating/Fan operation
Ensure the unit is plugged in and power is on.
1. Press the MODE button to select COOL, HEAT (cooling &
heating models only) or FAN mode.
2. Press the UP/DOWN buttons to set the desired
temperature.
3. Press the FAN button to select the fan speed in four
steps - Auto, Low, Med, or High.
4. Press the ON/OFF button to start the air conditioner.
NOTE:
In the FAN mode, the setting temperature is not displayed
in the remote controller and you are not able to control the
room temperature either. In this case, only steps 1, 3 and 4
may be performed.
3
1
2
2
MODE
SWING TEMP
SHORTCUT
FA N
SP E E D
TIMER
OFF
RE S E T LO C K
LED
FOLLOWME
TIM E R
ON
TURBO
SE LF CL EAN
DIRECT
SLEEP
FRESH
3
1
2
2
MODE
SWING TEMP
SHOR TCUT
FA N
SPE ED
TIMER
OF F
RESE T LOC K
LED
FOLLOWME
TIMER
ON
TURBO
SELF CLEAN
DIRECT
SLEEP
FRESH
4
1
2
2
MODE
SWING
TEM P
SHORTCUT
FA N
SP E E D
TIMER
OFF
RE S E T LO C K
LED
FOLLOWME
TIM E R
ON
TURBO
SE LF CL EAN
DIRECT
SLEEP
FRESH
3
E963_Lennox AC Remote Controller 20pp A5_1d.indd 10-11E963_Lennox AC Remote Controller 20pp A5_1d.indd 10-11 14/12/11 11:57 AM14/12/11 11:57 AM

Lennox LNIV2610 Specifications

General

Brand	Lennox
Model	LNIV2610
Category	Air Conditioner
Language	English