Lennox MPD40RNM User Manual

11
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
LENNOX HEARTH PRODUCTS • MERIT PLUS
®
DIRECT VENT GAS FIREPLACES (MPD33/35/40/45) • CARE AND OPERATION INSTRUCTIONS
Front Glass Enclosure Panel, Removal
and Installation
WARNING
Any safety screen or guard
removed for servicing the appli-
ance must be replaced prior to
operating the appliance.
AVERTISSEMENT
Tout écran ou protecteur retiré
pour permettre l’entretien de
l’appareil doit être remis en
place avant de mettre l’appareil
en marche.
WARNING
• Do not attempt to substitute the
materials used on this door, or
replace cracked or broken glass.
• Handle this glass with extreme
care! Glass is susceptible to
damage – Do not scratch or
handle roughly while reinstall-
ing the glass door frame.
• The glass door of this appli-
ance must only be replaced as a
complete unit as provided by the
manufacturer. Do not attempt
to replace broken, cracked or
chipped glass separately.
• Do not attempt to touch the front
enclosure glass with your hands
while the fi replace is in use.
WARNING
Do not operate appliance with
the glass front removed, cracked
or broken.
AVERTISSEMENT
Ne pas utiliser l'appareil si le
panneau frontal en verre n'est
pas en place, est craqué ou
brisé.
Only doors certifi ed with the appliance
shall be used.
Seules des portes certifi ées pour cet
appareil doivent être utilisées.
WARNING: DO NOT abuse glass door by
striking or slamming shut.
These are direct-vent appliances. They are
designed to operate only when the front glass
enclosure panels are installed. Generally
the front glass enclosure panel should not
be removed except to gain access to the
components within the fi rebox.
Removing Glass Enclosure Panels
(see Figure 4 )
Remove the top louver assembly or radiant
panel.
To access the glass door securing latches,
fi rst open the lower control compartment
door (Figure 4 ) by pushing in simultaneously
the left and right top corners of the door.
(The door is hinged at the bottom.) Remove
the bottom compartment door by sliding
the hinge pin, located at the door’s left side,
to the right until it disengages from the left
corner post hole. Pull the door diagonally to
the left, away from the fi replace.
Figure 4
Locate the two (2) latches at the top of the
control compartment and disengage them
from the door frame bottom vee-fl ange,
pulling down on their handles to open them.
REINSTALLING THE GLASS
ENCLOSURE PANEL
Retrieve the glass door. Visually inspect the
gasket on the backside of the frame. Gasket
surface must be clean, free of irregularities
and seated fi rmly.
Position the door in front of the fi rebox
opening with the bottom of the door held
away from the fi replace (Figure 4 ). Hook the
top fl ange of the door frame over the top of
the fi rebox frame.
Let the bottom of the door frame swing
gently in towards the fi replace ensuring that
the gasket seats evenly as the door frame
draws shut. Fasten the two latches located
underneath the fi rebox fl oor to the door's
vee-fl ange. Close both the latches securely.
Lower Compartment Door and Hinge
Glass Door Frame
Top Flange
Glass
Door
Glass Door Latch
Firebox Floor
Glass Door Frame
Bottom Vee-flange

Lennox MPD40RNM Specifications

General

Brand	Lennox
Model	MPD40RNM
Category	Indoor Fireplace
Language	English