4
1. LCD display 40
1.1. Key functions 40
1.2. Plain-text display 40
2. Basics of parameter setting 41
2.1. Change parameters 41
2.2. Save parameters 42
2.3. Load parameter 42
2.4. Examples 43
3. Commissioning 45
3.1. Basic parameter setting 45
3.2. Input of motor nameplate data 47
3.3. Setting of operating parameters 48
4. Additional functions 50
4.1. Mains failure detection with DC-bus control 50
4.1.1. Requirements 50
4.1.1. Wiring 52
4.1.2. Setting 53
4.2. Homing mode 56
4.3. Further additional functions 57
5. Serial interfaces 58
5.1. LECOM1 interface X1 58
5.2. LECOM status messages 59
5.3. Table of attributes 60
6. Code table 63
7. Signal flow chart axis modules 72
1. Monitoring messages 74
1.1. Monitoring without activating pulse inhibit 74
1.2. Monitoring with activating pulse inhibit 74
1.3. Monitoring with TRIP setting 74
2. LED displays 78
2.1. LED supply module 78
2.2. LED axis module 78
3. Checking the power stage 79
3.1. Checking the mains rectifier 79
3.2. Checking the output stage 79
Index
83
To Next Page
Loading...
Need help?
General
