Final works
Preparing the commissioning procedure
7
123
EDK94SH366 ZH/EN 3.1
7 Final works
7.1 Preparing the commissioning procedure
For commissioning you require the following:
ƒ A computer with Windows® operating system (XP or 2000)
ƒ The Lenze PC software »Engineer«
ƒ A connection to the controller via an interface, e.g.:
– Diagnostic interface X6 with USB diagnostic adapter
– System bus CAN
– Communication modules in the extension slots M1/M2
ƒ The Software Manual for the technology application used
ƒ The Communication Manual for the automation platform network
ƒ Mains voltage or 24−V voltage supply for control electronics of the controller
Follow the software instructions and/or read the documentation.
To Next Page
Loading...
Need help?
General
