LG 24MT49S User Manual

ENGENGLISH
9
Maintenance
Cleaning your TV
Clean your TV regularly to keep the best performance and to extend
the product lifespan.
y Make sure to turn the power o and disconnect the power cord
and all other cables rst.
y When the TV is left unattended and unused for a long time,
disconnect the power cord from the wall outlet to prevent
possible damage from lightning or power surges.
Screen, frame, cabinet and stand
To remove dust or light dirt, wipe the surface with a dry, clean, and
soft cloth.
To remove major dirt, wipe the surface with a soft cloth dampened
in clean water or a diluted mild detergent. Then wipe immediately
with a dry cloth.
y Avoid touching the screen at all times, as this may result in
damage to the screen.
y Do not push, rub, or hit the screen surface with your ngernail or a
sharp object, as this may result in scratches and image distortions.
y Do not use any chemicals as this may damage the product.
y Do not spray liquid onto the surface. If water enters the TV, it may
result in re, electric shock, or malfunction.
Power cord
Remove the accumulated dust or dirt on the power cord regularly.
Preventing “Image burn” or “Burn-in” on
your TV screen
y If a xed image displays on the TV screen for a long period of time,
it will be imprinted and become a permanent disgurement on
the screen. This is “image burn” or “burn-in” and not covered by
the warranty.
y If the aspect ratio of the TV is set to 4:3 for a long period of time,
image burn may occur on the letterboxed area of the screen.
y Avoid displaying a xed image on the TV screen for a long period
of time (2 or more hours for LCD) to prevent image burn.
Troubleshooting
Cannot control the TV with the remote control.
y Check the remote control sensor on the product and try again.
y Check if there is any obstacle between the product and the remote
control.
y Check if the batteries are still working and properly installed (
to , to ).
No image display and no sound is produced.
y Check if the product is turned on.
y Check if the power cord is connected to a wall outlet.
y Check if there is a problem in the wall outlet by connecting other
products.
The TV turns o suddenly.
y Check the power control settings. The power supply may be
interrupted.
y Check if the Sleep Timer / Timer Power Off is activated in the
Timers settings.
y Check if the Auto Power Off is activated in the General Eco
Mode settings. (Depending on model)
y If there is no signal while the TV is on, the TV will turn o
automatically after 15 minutes of inactivity.
When connecting to the PC (HDMI), 'No Signal' or ‘Invalid
Format’ is displayed.
y Turn the TV o/on using the remote control.
y Reconnect the HDMI cable.
y Restart the PC with the TV on.

LG 24MT49S Specifications

General

3D	No
Color depth	8 bit
Color gamut	72 %
Pixel pitch	0.38175 x 0.38175 mm
Screen shape	Flat
Response time	14 ms
Display diagonal	24 \
Display resolution	1366 x 768 pixels
Display technology	LCD
Native aspect ratio	16:9
Peak luminance ratio	66 %
Supported video modes	480i, 480p, 576i, 576p, 720p, 1080i, 1080p
Contrast ratio (dynamic)	5000000:1
Contrast ratio (typical)	1000:1
Display number of colors	16.78 million colors
Display diagonal (metric)	60 cm
Screen format adjustments	4:3, 16:9
Digital vertical frequency	56 - 75 Hz
Digital horizontal frequency	30 - 83 kHz
Display brightness (typical)	200 cd/m²
Supported graphics resolutions	1366 x 768
Motion interpolation technology	-
TV tuner integrated	Yes
Annual energy consumption	33 kWh
Analog signal format system	PAL, SECAM
Digital signal format system	DVB-C, DVB-S2, DVB-T2
RMS rated power	10 W
Number of speakers	2
Product color	Black
Mercury content	0 mg
Panel mounting interface	75 x 75 mm
Video compression formats	DivX
Tuner type	Analog & digital
Number of OSD languages	34
On Screen Display (OSD) languages	ALB, BOS, BUL, CRO, DAN, DEU, DUT, ENG, ESP, EST, FIN, FRE, GRE, HUN, ITA, KAZ, LAT, LIT, MAC, NOR, POL, POR, RUM, SER, SLK, SLV, SWE, TUR, UKR
HDMI version	1.4
DVI-D ports quantity	0
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Consumer Electronics Control (CEC)	SimpLink
AC input voltage	100 - 240 V
Power consumption (standby)	0.4 W
Power consumption (typical)	23 W
Cables included	AC
Package type	Box
Package depth	126 mm
Package width	700 mm
Package height	402 mm
Package weight	4500 g
Quantity per intermodal container (20ft)	704 pc(s)
Quantity per intermodal container (40ft, HC)	1672 pc(s)

Weight and Dimensions

Depth (with stand)	143.4 mm
Height (with stand)	392.7 mm
Weight (with stand)	3500 g
Depth (without stand)	54.7 mm
Width (without stand)	556 mm
Height (without stand)	345.2 mm
Weight (without stand)	3200 g