To Next Page

To Previous Page

ENGLISH

NOTE

• For [Screen Protection Mode] to work in the video wall, the monitors must be connected to the same network on the

LAN. However, some operations may be available when [LAN Daisy Chain] is connected and used. In this case, use a

router or a network switch.

• How to check the connection: Check the IP address in (SETTINGS) [General] [Network] [Wired

Connection (Ethernet)]. For more information, refer to Step 2: Configure the [Network].

Step 2: Configure the [Network] (when using the video wall mode)

1 Check the required equipment.

• Router or network switch router

• DHCP Server

- Used to allocate IP addresses in the network. Included in the router.

- Additionally required to configure the network with a network switch.

• Network cable (Ethernet cable)

- Used to connect the Ethernet port of the router (or network switch) and the Ethernet port of the Signage.

2 Check the network connection of the Signage.

• (SETTINGS) [General] [Network] [Wired Connection (Ethernet)]

- When the router is connected to the Internet: Make sure the connection status shows “Connected to Internet”.

- When the router is not connected to the Internet: Make sure the connection status shows “No Internet via

Ethernet”.

3 Check the IP address of the Signage.

• Check the IP address in (SETTINGS) [General] [Network] [Wired Connection (Ethernet)].

LG 32SM5E User Manual

Other manuals for LG 32SM5E