PREPARATION
7
PREPARATION
ACCESSORIES
Ensure that the following accessories are included with your product. If an accessory is missing, please contact
the dealer where you purchased the product.
User must use shielded signal interface cables (D-sub 15 pin cable) with ferrite cores to maintain standard
compliance for the product.
The accssories can be different from the figures shown here.
OOppttiioonn EExxttrraass
FFoorr LLCCDD TTVV mmooddeellss
Cable Management
4-Bolts for stand
assembly
(Refer to p.12)
For 37LB5D
This feature is not available for all models
FFoorr PPllaassmmaa TTVV mmooddeellss
Additional Cover
(Refer to p.13)
3- Bolts
(Refer to p.13)
* Slightly wipe stained spot on the exterior only with the polishing cloth
for the product exterior if there is stain or fingerprint on surface of the
exterior.
* Do not wipe roughly when removing stain. Please be cautions of that
excessive pressure may cause scratch or discoloration.
Polishing Cloth