Setup
66
Time synchronization
In the buttom right corner of the screen you have
another button that leads to a new screen where you
can synchronize the clock of your Navigator to the
very accurate time provided by the connected GPS.
Turn on the “Auto Correction” switch to let the
Navigator frequently check and correct the Navigator
time with the GPS time.
Below that button you will see the current values of
the GPS and the Navigator clocks.
You can check here whether any correction is needed.
Tap the button to manually synchronize the time.
Below the Navigator time you have hour and minute
controls to manually correct the time with or without a
valid GPS time. It also gives you the chance to correct
the time after synchronization if your Navigator does
not support time zones or daylight saving time.
Set Time Zone :
You will see the current values of
GMT, and use one time zone, Greenwich Mean TIME
(GMT).
To Next Page
General