ENGLISH
34
MAGIC REMOTE FUNCTIONS
MAGIC REMOTE FUNCTIONS
When the message
Magic Remote battery is low. Change the battery.
is displayed, replace the battery. To install
batteries, open the battery cover, replace batteries (1.5 V AA) matching
and ends to the label inside the
compartment, and close the battery cover. Failure to match the correct polarities of the battery may cause the battery
to burst or leak, resulting in fire, personal injury, or ambient pollution. Be sure to point the remote control at the
remote control sensor on the TV. To remove the batteries, perform the installation actions in reverse.
y
Do not mix old and new batteries, as this may damage the remote control.
CAUTION
This remote uses infrared light. When in use, it should be pointed in the direction of the TV’s remote sensor.
(POWER)
Turns the TV on or off.
Navigation buttons
(up/down/left/right)
Press the up, down, left or right
button to scroll the menu.
If you press
buttons while
the pointer is in use, the pointer
will disappear from the screen and
Magic Remote will operate like a
general remote control.
To display the pointer on the screen
again, shake Magic Remote to the
left and right.
(Home)
Accesses the Home menu.
(BACK)
Returns to the previous screen.
#
(EXIT to LIVE)
Switches among broadcast (antenna) and
various inputs.
Wheel (OK)
Press the center of the Wheel
button to select a menu.
You can change channels and
scroll the menu by using the
Wheel button.
VOL
Adjusts the volume level.
/INPUT
Displays the Screen Remote.
* Accesses the Universal Control Menu in
some regions.
* Pressing and holding the
button
will display a menu to select an external
device that is connected to the TV.
Used for viewing 3D video.
(MUTE)
Mutes all sounds.
* By pressing and holding the
button,
VD function will be enabled.
SAP(Secondary Audio Program) Feature can
also be enabled by pressing the
key.
.
CH
Scrolls through the saved channels.
(Voice recognition)
Network connection is required to
use the voice recognition function.
1. Press the voice recognition
button.
2. Speak when the voice display
window appears on the left of the
TV screen.
* Use the Magic Remote no further
than 10 cm (4 inch) from your face.
* The voice recognition may fail
when you speak too fast or too
slowly.
* The recognition rate may
vary depending upon the
user’s characteristics (voice,
pronunciation, intonation, and
speed) and the environment (noise
and TV volume).
Color buttons
These access special functions in some
menus.
(
Red, Green, Yellow, Blue)
/INPUT
VOL
CH
To Next Page
Loading...
Need help?
General
Weight and Dimensions
