20
This feature allows you to quickly verify that the exhaust system is adequate for the normal function of the
dryer. The check takes only two minutes. The results of the check are displayed in the FlowSense display
window as shown below
(Fig. 1). The dryer must be at room temperature for this test to be reliable. To perform this test, start the
machine in standby mode (power off). Press and hold both the DAMP DRY BEEP and the TEMP . CONTROL
buttons together while turning on the dryer with the POWER button i.e. Press together the three buttons DAMP
DRY BEEP + TEMP . CONTROL + POWER. The dryer will start and run for 2 minutes while it checks
temperatures. At the end of this short cycle, it will display the results as follows.
Fig.1
9-2 Installation check
PRESS TOGETHER
(Three buttons)
After installation check,
If the display shows….
If YES is shown in the display,
the ductwork is free from
blockages or restrictions.
If NO is shown in the display,
the dryer ductwork has a
blockage that needs to be
removed immediately.
OR
To Next Page
Loading...
Need help?
General
