13
INSTALLATION INSTRUCTIONS
Foam Tub Support Carton Base
NOTE
• Save the bolt assemblies for future use. To prevent
damage to internal components, DO NOT transport the
washer without reinstalling the shipping bolts.
• Failure to remove shipping bolts and retainers may
cause severe vibration and noise, which can lead to
permanent damage to the washer. The cord is secured
to the back of the washer with a shipping bolt to help
prevent operation with shipping bolts in place.
1
Remove the bottom two shipping bolts with the wrench
(included) to fully loosen all four shipping bolts by turning
them counterclockwise and then pulling them out.
2
Locate the four hole caps included in the accessory pack
and install them in the shipping bolt holes.
Unpacking and removing shipping
bolts
When removing the washer from the carton base, be sure
to remove the foam drum support in the middle of the
carton base.
If you must lay the washer down to remove the base
packaging materials, always lay it carefully on its side.
DO NOT lay the washer on its front or back.
Shipping
bolt
Retainer
Cap
To Next Page
Loading...
Need help?
General
