59
PROGRAMMING MODE - TEST MODE
Entering set up mode.
You will see LqC1
Button Display
Press the
Colors
or the
Perm.Press
button until
appears in the display.
Press the
START
button.
The display will cycle through 2000 --> 0101 --> Sat --> 0000 repeatedly.
Press the
START
button.
Press
Colors(+)
or
Perm.Press(-)
button to select year between 2000 and 2099.
Press the
START
button.
The machine sets up the year, then advances to the next process automatically.
Press
Colors(+)
or
Perm.Press(-)
button to select a month between 01 and 12.
Press the
START
button.
The machine sets up the month, then advances to the next process automatically.
Press
Colors(+)
or
Perm.Press(-)
button to select the day between 01 and 31.
Press the
START
button.
The machine sets up the day, then advances to the next process automatically.
Press
Colors(+)
or
Perm.Press(-)
button to select the hour between 00 and 23.
Press the
START
button.
The machine sets up the hour, then advances to the next process automatically.
Press
Colors(+)
or
Perm.Press(-)
button to select minute between 00 and 59.
Press the
START
button.
The machine sets up the minute.
1. Continue to set up the next mode.
2. Stop the change of setup value and go back to ready mode.
• Coin type - Turn on/off toggle switch.
• Card type - Pull the service card.
• OPL type - Push the Whites button twice.
3. Time set up
To Next Page
Loading...
Need help?
General
