REFRIGERATOR DISASSEMBLY
DISPENSER
1. Use a flat tip screwdriver to pry
the dispenser cover away from
the face of the door. Pry out at
the bottom; the dispenser folds
out at the top.
2. Pry gently to disengage the
plastic hooks without breaking
them off.
HINT: Put a small piece of tape
below the dispenser to avoid
scratching the finish.
3. Separate the connector before
pulling the dispenser away.
4. Replacement is the reverse of
these steps.
FILTER
Twist the filter
counterclockwise to remove
it. Insert the new filter and
twist it clockwise until it
clicks into place.
Put a cup under the hole at
the rear of the filter holder
to catch the drip when the
filter is removed.
LFX21960ST/LFX25960xx Page 24 of 75 TRAINING MANUAL