Operating48
Operating
4
Radio Operations
Be sure that the antennas are connected.
(Refer to the page 20)
Listening to the radio
1. Press RADIO&INPUT until TUNER (FM/AM)
appears in the display window. The last received
station is tuned in.
2. Press and hold TUNING (-/+) for about two
seconds until the frequency indication starts to
change. Scanning stops when the unit tunes in
a station. Or Press TUNING (-/+) repeatedly.
3. Adjust the volume by rotating VOLUME on
the front panel or by pressing VOL (+/-) on the
remote control.
Presetting the Radio Stations
You can preset 50 stations for FM/AM.
Before tuning, make sure that you have turned
down the volume.
1. Press RADIO&INPUT until the TUNER (FM/AM)
appears in the display window.
2. Select the desired frequency by using TUNING
(-/+).
3. Press ENTER (
b
) a preset number will ash in
the display window.
4. Press PRESET (-/+) to select the preset number
you want.
5. Press ENTER (
b
). The station is stored.
6. Repeat the steps 2 to 5 to store other stations.
Deleting a saved station
1. Press PRESET (- / +) to select a preset number
you want to delete.
2. Press CLEAR, the preset number will blink in the
display window.
3. Press CLEAR again, to delete the selected preset
number.
Deleting all the saved stations
Press and hold CLEAR for two seconds.
“ERASE ALL” will ash up. Press CLEAR again. Then all
the saved stations are deleted.
Improving poor FM reception
Press B (blue) (MONO/STEREO) colored button on
the remote control. This will change the tuner from
stereo to mono and usually improve the reception.
HB926_ENG.indd 48 11. 03. 04 �� 5:14
To Next Page
Loading...
Need help?
General
