11
ASSEMBLING AND PREPARING
ENGENGLISH
Mountingonatable
1
Lift and tilt the TV into its upright position on a
table.
- Leave a 10 cm (minimum) space from the
wall for proper ventilation.
2
Connect the power cord to a wall outlet.
SecuringtheTVtoatable
Fix the TV to a table to prevent from tilting forward,
damage, and potential injury.
Mount the TV on a table, and then insert and
tighten the supplied screw on the rear of the stand.
CAUTION
Do not place the TV near or on sources
of heat, as this may result in fire or other
damage.
WARNING
To prevent TV from falling over, the TV
should be securely attached to the floor/
wall per installation instructions. Tipping,
shaking, or rocking the TV may cause injury.
10cm
10cm
10cm
10cm
AttachingtheTVtoatable
Image shown may differ from your TV.
The TV must be attached to desk so it cannot be
pulled in a forward/backward direction, potentially
causing injury or damaging the product.
(Only 37/42/47LN54
**
, 37/42LP36
**
, 37/42LP63
**
)
Screws: M4 x L (*L: Table depth + 8-10 mm)
ex) Table depth: 15mm, Screw: M4 x 20
(not provided as parts of the product)
4-Screws
Stand
Table
To Next Page
Loading...
Need help?
General
