1. Press button for 4 seconds to
enter the installer setting mode until
timer segment display “01:01”.
2. Repeat pressing button to select Function code
04.
3. Set Thermistor mode by pressing
button
(01: Remote Controller,
02: Indoor, 03: 2TH)
4. Press button to save or release
5. Press button to exit or system
will automatically exit after 25 seconds
without any input.
❈ Therefore system will use value that sensed from indoor unit or remote controller
❈ If you want to know more Optional Operation, please refer to Wide Wired Remote Controller Manual.
Two Thermistor System
Temperature sensor location Function
01 Remote controller Operation in remote controller Temperature sensor
02 Indoor unit Operation in indoor unit temperature sensor
03 2-Thermistor
Operation in lower temperature after comparing the temperature
between the indoor unit and remote controller
To Next Page
Loading...
Need help?
General
