Using Instant Recording
To end the recording, press the button on the remote control during recording and
select Record.
Matters That Require Attention of Recording
While recording, press the Wheel (OK) button to display information about the recording.
The Wheel (OK) button operation may vary depending on the country.
You can set recording time before the recording starts, and during the recording, you can
change the time by selecting the Record button.
If multiple USB storage devices are connected, the last recorded storage device is selected
automatically.
The available capacity of the USB HDD partition must be at least 1 GB.
There must be at least 4 GB of partition size on USB stick.
The recordable time may vary depending on the capacity of your USB storage device.
Upon the initial attempt to record to the USB memory, the TV will perform a performance
test. Start recording after the test has been completed normally.
Because of the content protection technology used, the recorded video cannot be played
on PCs or other TV models. Also, the video cannot be played if the TV’s video circuit is
replaced.
Do not remove the USB cable while recording.
If you force your TV to power off while recording, the recorded content may not be saved.
Ideally, you should stop the recording and check that the programme has been recorded
Connect a USB HDD or USB stick to a USB port.
It is recommended that you record to a USB HDD.
01
Press the button on the remote control and select Record.
If your remote control does not have a button, press and hold the button.
02
To Next Page
Loading...
Need help?
General
Weight and Dimensions
