E.S.P(DUCT TYPE)
1
If you press the Timer button and the Fan Speed
button simultaneously for about 3 seconds, you can
enter the ESP value setting mode.
2
Using the Temperature Adjustment button, set the
ESP value for each wind level (Low, Mid, High). Use
the Wind button to decide the Fan Speed. (The ESP
value can be set between 1 to 255.)
3
After completing the ESP setting, press the Timer
button and Fan Speed simultaneously again for about
3 seconds to exit the ESP value setting mode.
* Because the ESP value is already appropriately set when manufactured from the factory, it is
recommended that you do not change the ESP value.
12 Weekly Wired Remote Controller
What is an E.S.P function?
This is the function that decides the strength of the wind for each wind level and because this function is to make
the installation easier, please do not use this function when using the remote controller.
To Next Page
Loading...
Need help?
General
