Room Temp
Operation unit
Set no.
Time
Program set
Timer
On
Time
Off
01 03 05 07 09 11 13 15 17 19 21
23
ZONE
1234
JET
Heater
Defrost
Preheat
Humidify
Filter
Out door
AUTO SWING
OPERATION SET TEMP FAN SPEED
SUB FUNCTION
MED
LO
AUTO
HI
Timer
Program
Hour
Cancel 2ndF
Week Holiday
Set/Clr
Min
RESET
PLASMA
2ndF
Room Temp
Operation unit
Set no.
Time
Program set
Timer
On
Time
Off
01 03 05 07 09 11 13 15 17 19 21
23
ZONE
1234
JET
Heater
Defrost
Preheat
Humidify
Filter
Out door
AUTO SWING
OPERATION SET TEMP FAN SPEED
SUB FUNCTION
MED
LO
AUTO
HI
Timer
Program
Hour
Cancel 2ndF
Week Holiday
Set/Clr
Min
RESET
PLASMA
2ndF
Fan Speed operation
Fan Speed operation
Fan Speed selector
Air flow direction control
FAN Speed selection. You can easily adjust the FAN Speed
You can simply control the air flow direction as you wish.
1
Press the FAN Speed button to set the desired strength
of the wind.
2
Every time you press the FAN Speed button, the
strength of the wind will switch from super low (Only for
applicable model) → low → Mid → High → Auto (Only
for applicable model) → Power (Only for cooling).
The initial FAN Speed during the operation is “High”.
1
Press the ON/OFF button.
2
First press the 2ndF button to control left and right
direction of the wind.
You will see the 2ndF sign on the screen.
4
To cancel the left/right operation of the wind, press the
Left/Right Wind button.
3
Press the left/right wind button.
5
Press the Up/Down Wind button.
6
To cancel the up/down operation of the wind, press the
Up/Down Wind button one more time.
If you press both the Up/Down Wind and the Left/Right Wind button, all the wind direction bars will be highlighted.
The Up/Down Wind and Left/Right Wind function only works with the cassette type remote controller. It does not
work in the duct type remote controller.
Left/Right Wind function only works in the model with the left and right function. When it does not operate, it will
show the “No function” sign.
if indoor's type is SRAC which not operates left/right wind function,
It will not show the "No function" sign although press the left/right button.