LG WT7300CW User Manual

10 INSTALLATION
f Connecting to the Power Supply
g Final Installation Check
Tools Needed
a Pliers
b Flat-Blade Screwdriver
c Level
Choosing the Proper
Location
Check the following requirements for the install
location before installing the washer.
• Allow for sufficient space between the walls and
the washer for installation.
• Make sure that the floor is clean, dry and free of
dust, dirt, water and oil so the leveling feet
cannot slide easily. Leveling feet that can move
or slide on the floor can contribute to excess
vibration and noise.
• If the floor has too much flex, reinforce it to
make it more rigid. If the floor is not solid, it may
cause severe vibration and noise.
Power Outlet
The power outlet must be within 60 inches (1.5 m)
of either side of the washer.
• Position the washer so that the outlet and plug
are easily accessible.
• Do not overload the outlet with more than one
appliance.
• The outlet must be grounded in accordance with
current electrical wiring codes and regulations.
• Use a time-delay fuse or circuit breaker.
• It is the personal responsibility and obligation of
the washer owner to have a proper outlet
installed by a qualified electrician.
Flooring
• To minimize noise and vibration, install the
washer on a level, solidly constructed floor
capable of supporting the washer without
flexing or bouncing.
• The washer must be installed on firm flooring to
minimize vibration during the spin cycle.
Concrete flooring is best, but a wood floor is
sufficient, provided it is built to FHA standards.
• The floor under the washer must not slope more
than 1 inch (2.5 cm) from front to back or side to
side.
• Installing on carpeting and soft tile surfaces is
not recommended.
• Never install the washer on a platform or weakly
supported structure.
Floor Installation
To ensure sufficient clearance for water inlet
hoses, drain hose and airflow, allow minimum
clearances of at least 1 inch (2.5 cm) at the sides
and 4 inches (10 cm) behind the washer. Be sure
to allow for wall, door, or floor moldings that may
increase the required clearances.
Minimum vertical space from floor to overhead
shelves, cabinets, ceilings, etc., is 58 inches (147
cm).
Dimensions and Clearances
A 1” (2.5 cm)
B 27” (68.6 cm)
C 44 1/2” (113 cm)
C
BAA
D
E
H
G
F

LG WT7300CW Specifications

General

Style	top load
Color	white
Washer Capacity	5 cubic feet
Max Spin Speed	950 revolutions per minute
Spin Speeds	5
Number of Cycles	8
Cycle Selections	normal, heavy duty, deep wash, waterproof, pre wash+ normal, delicates, bedding, downloaded
Options	soak, extra rinse, add garments, delay wash, control lock, water plus, coldwash, rinse+spin, spin only, staincare, tub clean, signal, remote start, wi-fi
Temperature Settings	5
Temperature Selections	hot, warm, semi warm, cold, tap cold
Soil Levels	heavy, normal, light
Internal Heater	no
Control Panel	dial, touchpad
Delay Start / End	yes
Child Lock	yes
Cycle Signal	yes
Interior Light	no
Steam	no
Dispenser	single load
Smart Home	smartdiagnosis, energy monitoring, cycle monitoring, remote start, maintenance alerts, performance tips, true
Wi-Fi	wi-fi
Annual Energy Consumption	110 kilowatt hours
Voltage	120 volts
Current	15 amperes

Weight and Dimensions

Depth	28 3/8 inches
Height	44 1/2 inches
Width	27 inches
Net Weight	146.9 pounds