22 OPERATION
Control Panel
Control Panel Features
a Power On/Off Button
• Press this button to turn the washer on or off.
• Pressing this button during a cycle will cancel that cycle and any load settings will be lost.
• The door will unlock after a brief pause.
• If there is any water remaining in the drum after the washer shuts off, it will drain after a delay. The
washer can be restarted at any time before the drain begins. However, once the water begins to drain,
all functions will be suspended until the water has been completely drained and the washer shuts off.
b Cycle Selector Knob
• Turn this knob to select the desired cycle.
• Once the desired cycle has been selected, the standard presets will appear in the display. These
settings can be adjusted using the Cycle Modifier buttons at any time before starting the cycle.
c Start/Pause Button
• Press this button to start the selected cycle.
• If the washer is running, use this button to pause the cycle without losing the current settings.
• If the Start/Pause button is not pressed to start the selected cycle, after a delay the washer
automatically turns off and all cycle settings are lost. Any water remaining in the drum will be drained.
d Time and Status Display
e Cycle Modifier Buttons
• Use these buttons to adjust the wash temperature, spin speed and soil level settings for the selected
cycle.
• The current settings are shown in the display.
• Press the button for that option to select other settings.
f Option and Extra Function Buttons
• These buttons allow you to select additional cycle options. Certain buttons also allow you to activate
special functions by pressing and holding the button for 3 seconds.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
