LG WT7300CW User Manual

12 INSTALLATION
NOTE
• Do not stretch the water hoses intentionally, and
make sure that they are not pinched, crushed or
kinked by other objects.
• Water supply pressure must be between 20 psi
and 120 psi (138 - 827 kPa). If the water supply
pressure is more than 120 psi, a pressure
reducing valve must be installed.
• Your hot water heater should be set to deliver
water at 120 - 135°F (48 - 57°C) to allow the
washer to properly control wash temperatures.
• Do not store or install the washer in a location
subject to freezing temperatures. Damage to the
water inlet hoses and internal mechanisms of
the washer can result. If the washer was
exposed to freezing temperatures prior to
installation, allow it to stand at room
temperature for several hours before use and
check for leaks prior to operation.
• Do not use flood-preventing hoses with auto
shutoff devices. The devices can be tripped
during fill and prevent the washer from filling
properly.
How to Connect the Water Inlet
Hoses
1 Check the fittings and seals.
• Inspect the threaded fitting on each hose
and make sure there is a rubber seal
a in
place in both ends of each hose to prevent
leaking.
2 Connect the water supply hoses.
• Connect the water inlet hoses to the hot
and cold water faucets tightly by hand and
then tighten another 2/3 turn with pliers.
• Connect the blue hose to the cold water
faucet and the red hose to the hot water
faucet.
3 After the hoses are connected, turn on the
water faucets and flush out any foreign
substances such as dirt, sand, or sawdust.
• Let the water drain into a bucket, and check
the water temperature to make sure you’ve
connected the hoses to the correct faucets.
4 Attach the inlet hoses to the back of the
washer.
• Attach the hot water inlet hose to the hot
water inlet on the back of the washer.
Attach the cold water inlet hose to the cold
water inlet on the back of the washer.
• Tighten the fittings securely. Turn on both
faucets all the way and check for leaks at
both ends of the hoses.
Connecting the Drain Hose
Connect the drain hose to either a standpipe or
laundry tub.
WARNING
• The drain hose should always be properly
secured. Failure to properly secure the drain

LG WT7300CW Specifications

General

Style	top load
Color	white
Washer Capacity	5 cubic feet
Max Spin Speed	950 revolutions per minute
Spin Speeds	5
Number of Cycles	8
Cycle Selections	normal, heavy duty, deep wash, waterproof, pre wash+ normal, delicates, bedding, downloaded
Options	soak, extra rinse, add garments, delay wash, control lock, water plus, coldwash, rinse+spin, spin only, staincare, tub clean, signal, remote start, wi-fi
Temperature Settings	5
Temperature Selections	hot, warm, semi warm, cold, tap cold
Soil Levels	heavy, normal, light
Internal Heater	no
Control Panel	dial, touchpad
Delay Start / End	yes
Child Lock	yes
Cycle Signal	yes
Interior Light	no
Steam	no
Dispenser	single load
Smart Home	smartdiagnosis, energy monitoring, cycle monitoring, remote start, maintenance alerts, performance tips, true
Wi-Fi	wi-fi
Annual Energy Consumption	110 kilowatt hours
Voltage	120 volts
Current	15 amperes

Weight and Dimensions

Depth	28 3/8 inches
Height	44 1/2 inches
Width	27 inches
Net Weight	146.9 pounds