LG WTG6520 User Manual

15
AU
Connecting the Inlet Hoses to the
Appliance
Attach the hot water line to the hot water inlet
on the back of the washing machine. Attach the
cold water line to the cold water inlet on the
back of the washing machine.
NOTE
• After completing connection, if water leaks
from the hose, repeat the same steps. Ensure
that the rubber washers are fitted to both
sides of the hose.
Installing the Drain Hose
Before connecting the drain hose, check your
drain hose model and choose the correct
instruction.
Pump Model (Australia and other
countries)
• The drain hose should not be placed higher
than 120 cm above the floor. Water in the
washing machine may not drain or may drain
slowly.
• Securing the drain hose correctly will protect
the floor from damage in the event of water
leakage.
• If the drain hose is too long, do not force it
back into the washing machine. This will
cause abnormal noise.
• When installing the drain hose to a sink,
secure it tightly with string.
0.9 - 1.2 m
0.9 - 1.2 m
Laundry tub
Hose
retainer
Tie strap
NOTE
• The discharge height should be approximately
0.9 - 1.2 m from the floor. Do not lay the drain
hose on the ground, it must be connected to a
laundry tub or stand pipe.

LG WTG6520 Specifications

General

Brand	LG
Model	WTG6520
Category	Washer
Language	English