Linksys VELOP User Manual

4
Bottom view
1. Reset button------Press and hold until the light on top of the node turns red, fades and flashes
bright red again to reset the router to its factory defaults.
2. Ethernet ports------Connect Ethernet cables to these Gigabit Ethernet (10/100/1000) ports
and to other wired devices on your network. If you have more than one node in your Velop
system, use one of these ports to connect to your modem or modem router.
Note—For best performance, use a CAT5e or higher rated cable on the Ethernet port.
3. Power switch------Press | (on) to power on the node.
4. Power port------Connect the included AC power adapter to this port.

Linksys VELOP Specifications

General

2.4 GHz	Yes
MIMO type	Multi User MIMO
Modulation	256-QAM
Fit AP mode features	Dual-MPP mesh networking, Mesh networking
Networking standards	IEEE 802.11a, IEEE 802.11ac
WLAN channel features	WLAN channel management
Ethernet LAN data rates	1000 Mbit/s
Maximum data transfer rate	1267 Mbit/s
Maximum data transfer rate (5 GHz)	867 Mbit/s
Maximum data transfer rate (2.4 GHz)	400 Mbit/s
Flash memory	256 MB
Management platform	Linksys
Internal	No
Placement	Table
Certification	FCC, IC, CE
Product color	White
LED indicators	Power, Status
Housing material	Plastic
Security algorithms	WPA2-PSK
Service Set Identifier (SSID) features	Hidden SSID
WAN connection	Ethernet (RJ-45)
USB 2.0 ports quantity	0
Ethernet LAN (RJ-45) ports	2
Storage temperature (T-T)	-20 - 60 °C
Operating temperature (T-T)	0 - 40 °C
Storage relative humidity (H-H)	5 - 90 %
Operating relative humidity (H-H)	10 - 80 %
Antenna features	Integrated antenna
Antennas quantity	3
Cables included	LAN (RJ-45)
Number of products included	1 pc(s)
Harmonized System (HS) code	85176990

Weight and Dimensions

Width	78.74 mm
Height	139.7 mm
Weight	320 g