Rev: 12.27.2017
Page 8
LCI Level-Up Motorized Leveling Winnebago Industries up to 9-2015 Owner's
Features
A. Automatic extension of jacks from full retract position (with automatic ground detection).
B. Automatic leveling of jacks.
C. Manual leveling of jacks
D. Automatic retraction of jacks (with automatic full retract detection).
E. Air bag suspension features (configurable on/off).
F. Emergency retract/User alarm mode (jacks not retracted and park brake disengaged).
G. Automatic jack error detection and error mode.
H. Configurations mode for Leveling Zero Point.
I. Remote operation.
System Wiring Requirements
A. Battery power (2 ga. SAE J1127. Type SGX).
B. Battery ground (2 ga. SAE J1127. Type SGX).
C. Logic power (switched via ignition).
D. Power brake signal (open=park brake disengaged, GND=park brake engaged).
E. 4-wire harness connecting Controller to Touch Pad.
F. Jacks status input - Switched to GND.
I. Jacks not all up – switch closed to ground .
II. Jacks all up – switch open.
Air and Auxiliary Features (When Applicable)
System has the option to control external Air and Auxiliary features.
When enabled, the feature works according to the following logic:
A. Air bag pressure automatically lowers when starting the auto or manual level sequence to
maximize lift of jacks.
B. Air bag pressure automatically increases when starting an auto retract sequence.
C. If the parking brake is disengaged, jacks will automatically retract without the 25 second delay. Air
bags will fill during and after this emergency retract.
NOTE: When retracting in manual mode, the air bags will not fill automatically and must be done manually.
The Manual Air Bag Dump/Fill functions as follows:
1. Set park brake.
2. Scroll up twice to “MANUAL AIR CONTROL”.
3. Press enter.
4. Press REAR button (Fig. 5I) to dump, FRONT button (Fig. 5H) to fill.
To Next Page
Loading...
Need help?
General
