Logik L24DVDB19 User Manual

GB-13
PreparationConnectionsInitial SetupUsing the FeaturesDVR (Digital
Video Recorder)
Using the Features
via USB port
Using the DVD
Features
Hints and Tips, Specification
and Safety Warnings
Connecting a PC with VGA Cable
Use a VGA cable to connect the PC’s VGA output jack 1.
to the TV’s VGA IN jack. Use an audio cable to connect
the PC’s audio output jacks to TV’s VGA LINE IN jack.
Plug the connected devices into the mains socket 2.
before switching on the POWER ON/OFF switch at
the bottom of the TV.
Press the3.
/ I button on the top panel of the TV or
the
button on the remote control to turn on your
TV.
Press the 4. SOURCE button on the remote control to
display the Source List. Use the
buttons to select
PC, and then press the OK button or the
button.
The best resolution of L24DVDB19 is 1920 * 1080.
If you set your computer to shut down after a few
minutes of idle mode, the TV might also be in standby
mode due to no signal.
To avoid this happening, you will need to configure
the PC computer.
Follow the steps below.
At your computer’s desktop screen, click on Start.1.
Select Control Panel.2.
Double-click on Power Options and choose NEVER 3.
to turn off the monitor.
Then, in Display Properties, set the screensaver as 4.
blank instead.
The TV will not be in standby mode now even though
the PC computer is not in use.
Connecting an A/V Device with HDMI Cable
This TV can accept High-Definition Multimedia Interface (HDMI).•
This TV SET supports HDCP (High-Bandwidth Digital Content Protection) Protocol.•
When you connect to the output of an HD ready player (Blu-ray Disc Player, Game Console, Set Top Box or PC) switch to the •
HDMI function and the TV will automatically detect the resolution used by the HDMI source.
To get the best picture quality, adjust the Blu-ray Disc Player, Game Console or Set Top Box output resolution up to 1920 x •
1080p.
Use a HDMI cable to connect the A/V device’s HDMI 1.
output jack to the TV’s HDMI IN jack.
Plug the connected devices into the mains socket 2.
before switching on the POWER ON/OFF switch at
the bottom of the TV.
Press the3.
/ I button on the top panel of the TV or
the
button on the remote control to turn on your
TV.
Press the 4. SOURCE button on the remote control to
display the Source List. Use the
buttons to select
HDMI, and then press the OK button or the
button.
The HDMI connector provides both video and
audio signals, it’s not necessary to connect the
audio cable.
VGA Cable
(not included)
Audio Cable
(not included)
Rear View of TV
PC
Rear View of TV
HDMI Cable
(not included)
Blu-ray Player / DVD Player /
Recorder
Set-top BoxGame Console

Logik L24DVDB19 Specifications

General

Brand	Logik
Model	L24DVDB19
Category	TV DVD Combo
Language	English