25
Adding Salt
If the water in your area is hard, deposits will form on your dishes and utensils. As such, this appliance contains a
salt reservoir for you to reduce the hardness of the water.
Please follow the steps below to pour the salt into the salt reservoir and to correspond to the water hardness level
in your area.
1. Remove the basket and unscrew the reservoir cap.
2. Place the funnel provided over the salt reservoir. Pour in
approximately 1.2kg of dishwasher salt depending on the brand
used.
3. Fill the reservoir with water until it overows (rst use only).
4. Clean any excess salt from around the reservoir opening and then
screw the cap on again rmly.
5. Run the P3 wash programme immediately (without any crockery
in the dishwasher) to remove any traces of salt from the
compartment.
open
open
open
• The salt rell warning indicator on the control panel will illuminate when the reservoir is running
out of salt and requires relling.
• The salt rell warning indicator will cease to illuminate within a few days, depending on how
quickly the salt dissolves.
• If you decide to use a detergent tablet, you may not need to add salt, this depends upon the water
hardness in your area and the type of tablet being used. Check with your water supplier and the
detergent tablet manufacturers instructions.
LDW2PB19N_IB_5L_Final190531.indb 25 31/5/2019 6:00 PM
To Next Page
Loading...
Need help?
General
