EasyManuals Logo
Home>Logik>Dishwasher>LDW2PB19N

Logik LDW2PB19N User Manual

Logik LDW2PB19N
124 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #30 background imageLoading...
Page #30 background image
30
GB
If the dishwasher is not going to be used for a long period of time, e.g. whilst on holiday, disconnect
the unit from the mains supply and turn o the water supply.
Starting a Wash Cycle
1. Ensure the unit is connected to the mains power and the water supply is fully opened (water pressure
between 0.04MPa and 1.00MPa), or if not connected to the water supply, ensure the dishwasher tank is full of
water.
2. Open the door. Pull out the dishwasher basket, load the dishes and push the basket back.
3. Pour in the detergent or place the detergent tablet.
4. Close the dishwasher door. A click sound should be heard when the door is closed correctly. Do not slam the
door.
5. Press the
button.
6. Select the wash cycle programme based on the loading and soil requirements. Please refer to the section
Wash Cycle Table.
7. The indicator light of the selected programme will illuminate.
8. Press the
button, the washing cycle will begin shortly.
Changing a Programme
You can change the washing programme if it has just started for a short time.
Press the
button to pause the washing. Then press and hold P until the unit becomes standby state. Press P
again to select the new programme and conrm the selection by pressing the button. The unit will start the new
washing cycle shortly.
At the End of a Programme
At the end of the programme, the dishwasher will beep.
Switching O the Unit
To save energy, remember to switch the dishwasher o using the button. The dishwasher will continue to use
electricity unless it is switched o with the button. Turn o the water supply.
If you open the dishwasher’s door during the washing cycle and then close it, the dishwasher will
continue the current washing programme after 10 seconds.
Unloading the Dishwasher
Allowing dishes to cool down before unloading is important as dishes tend to break and chip more easily when
they are hot. Therefore, if you open the dishwasher door fully after switching o, it will allow the dishes to cool
down much faster.
You can add dishes to wash after the washing programme has begun for a short time.
Press the
button to pause the washing. Open the door, add the dishes then close the door. Press the
button to resume the washing.
LDW2PB19N_IB_5L_Final190531.indb 30 31/5/2019 6:00 PM

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Logik LDW2PB19N and is the answer not in the manual?

Logik LDW2PB19N Specifications

General IconGeneral
BrandLogik
ModelLDW2PB19N
CategoryDishwasher
LanguageEnglish

Related product manuals