GB-18
Before Use Operation Cleaning and Maintenance Specification Safety Warnings
Spray Arms
Particles of food can get stuck in the spray arm jets and bearings. The spray arms should therefore
be checked and cleaned regularly.
1. Ensure the dishwasher is switched off.
2. Use a pointed object, for instance a cocktail stick, to loosen food particles in the spray arms’ jets.
• Do not attempt to remove the spray arms.
Frost Precaution
Avoid placing the dishwasher in a location where the temperature is below 0˚C. If your appliance is left in
an unheated place over the winter, you are advised to:
1. Disconnect the unit from the water inlet.
2. Turn on the unit. Select any washing cycle and let it runs for 1 minute only. This allows to drain out
all the excessive water that remains in the unit.
3. Disconnect from the mains.
4. Empty the dishwasher.
5. Close the dishwasher’s door.
6. Disconnect the unit from the water drain. Use a suitable receptacle to catch the water.
Should you encounter any difficulties with the above steps, please ask a service technician for assistance.
Maintenance After Prolonged Period of Non-Operation
If you are not going to use the unit for any prolonged period of time, you are advised to:
1. Disconnect the dishwasher from the mains.
2. Disconnect the dishwasher from the water inlet and drain. Use a suitable receptacal to catch the
water.
3. Slightly open the door to prevent unpleasant smells building up in the compartment.
4. Ensure the washing compartment of the dishwasher is clean.
Should you encounter difficulties to do the above steps, please ask a service technician for assistance.
Logik LDW45S10_IB_100324.indd 18 3/24/10 3:24 PM
To Next Page
Loading...
Need help?
General
