4 -11
(5) Stopping tractor
Caution
▶ DO NOT leave the tractor while the transmission gear is placed in the neutral
position and the parking brake is not applied. The tractor may roll down.
Apply the parking brake at all times before leaving the tractor.
▶ Remove the ignition key always after stopping engine.
Mechanical type
Cabin
Parking brake lever
Roll-bar
1. Press the clutch and brake pedals. Pull the
throttle lever to “Low” speed position. Place
the shuttle lever, main gear shift lever in
NEUTRAL and PTO switch to “OFF” position.
3. Apply parking brake and release the brake
pedals and clutch pedal slowly.
2. Lower the implements to the ground and
turn key switch to “OFF” position.
1. Release the HST forward/reverse pedal
slowly. Pull the throttle lever to “Low” speed
position. Place the range gear shift lever in
NEUTRAL and PTO switch to “OFF”
position.
3. Apply parking brake and release the brake
pedals slowly.
2. Lower the implements to the ground and
turn key switch to OFF position..
HST Type
Brake pedals
Clutch pedal
Throttle lever
Key switch
HST forward pedal
Throttle lever
HST reverse pedal
Brake pedals
Key switch