5 -32
(8) Cleaning Cabin air filters
Before servicing the filters, switch off the blower
and close all the cabin doors and windows.
Unscrew the knobs under the roof and remove
the cover and filter element as shown in the right
figure.
Clean the elements by blowing with compressed
air not exceeding 30psi (2bar). Blow the dust
from the upper surface through the element to
the underside. Hold the nozzle at least 12 in.
(300mm) from the element to prevent damage to
the filter media.
Clean all filter chambers with a damp, lint-free
cloth. Re-install the filter elements.
Re-install the filter cover and tighten the knobs.
▶ The filters are made of specially treated media with a rubber sealing strip bonded
around the sides. Take care not to damage the element during installation.
Notice
Cabin
air filters
Knobs
Filter
cover
(7) Hydraulic hoses and Leakage
Stop the engine and place all the transmission
gears in neutral and lower down the implement
to the ground.
Periodically check the hydraulic system for leaks
or damaged parts - kinked, crushed, flattened,
hard blistered, heat cracked, charred, twisted,
soft or loose covered hoses and fittings.
Before removing hydraulic components, make
sure to check that the hydraulic pressure is
relieved completely. The leaks of pressurized oil
can cause a fatal physical injury.
For further information, refer to the chapter 3-5,
“Hydraulic system” in this manual.
To Next Page
Loading...
Need help?
General
