3 -19
â‘¥ Inhibited regeneration mode
NOTICE : Only use this mode when regeneration
needs to be delayed or stopped because of an
operation condition that may risk a fire hazard due
to high exhaust temperatures during regeneration.
NOTE : Even if the DPF regeneration indicator(1)
is ON during the regeneration process, the
inhibited regeneration mode can be set.
The regeneration mode can be delayed or
stopped by the use of the DPF switch(3) that is
located on the left-hand side of the dash.
To set the inhibited regeneration mode :
1. Press down the lower side(B) of the DPF
switch(3). And then DPF inhibited regeneration
indicator(2) will be turned on.
NOTICE : When tractor arrives at a safe
regeneration location, press again the lower
side(B) of the DPF switch to exit the Inhibited
regeneration mode.
If not, excessive soot in the DPF may overload the
emission system and result in a reduction of
engine power.
B
A
To exit the Inhibited regeneration mode (To go
to the regeneration mode) :
1. Press down the lower side(B) of the DPF
switch(3) again for only exiting the inhibited
regeneration mode.
2. Press and hold the upper side(A) of the DPF
switch(3) for over one second to exit the
Inhibited regeneration mode and to execute the
regeneration mode.
3. When inhibited regeneration mode has been
exited, the DPF inhibited regeneration indicator
(4) will be turned off.
NOTE: If the tractor is shut off during the inhibited
mode, when restarting the tractor, the
regeneration system will return to the
regeneration mode.
A:
B:
1
2
3
To Next Page
Loading...
Need help?
General
