luxvision LRK-7000 User Manual

74
2) Check list
When
Remedy
The LCD does not turn
on.
- The power cord may not be correctly connected. Reconnect it
securely
- Check whether proper voltage is applied to the power outlet.
- The power switch may not have been turned on. Check the
power switch.
The LCD does not turn
on(not clear) even
though power is on
- The sleep function may have been activated. Press joystick
button (or touch the screen) to exit from sleep mode.
The screen disappears
suddenly.
- Sleep mode may have been activated. Press joystick button (or
touch the screen) to exit from sleep mode.
The main body cannot
be moved laterally
- The stage fixation lever may be locked. Unlock the stage
fixation lever at the back of the joystick.(Refer to 6 phase)
- The body lock may be locked. Unlock the body lock on both
sides of the main body. (Refer to 6 phase)
- The clamping bolt may be locked. Unlock the clamping bolt on
the bottom of the device. (Refer to 6 phase)
Print does not start
- Check the printer paper. If the paper has been used up, load
new printer paper.
The printer does
operate, however,
printed results cannot be
obtained.
- The printer paper may be loaded with the incorrect side up. Set
it with the correct side up.
Printer paper does not
feed properly
- Printer paper may be loaded in tilted or the core of the roll may
not be placed properly. Open the printer cover and make sure
that printer paper is properly loaded.
10.6. When moving equipment installation place
1) Turn off the main body’s power switch.
2) Separate power connection cable.
3) Lock by turning the Clamping bolt into the clockwise direction.
4) Move while maintaining horizontal balance while holding the lower part of the main body.

luxvision LRK-7000 Specifications

General

Brand	luxvision
Model	LRK-7000
Category	Medical Equipment
Language	English