35 Series-HST, Model - 3535, 4035, 4535 & 5035
51
Three Point Linkage
Toplink
It is used to attach the implement and control its inclination
front-to-rear with respect to ground. The distance between
its two ball-joints can be increased or decreased by rotating
the turn-buckle as follows,
1. Loosen the lockplate (A).
2. Clockwise rotation of turn buckle will increase the
distance.
3. Anti-clockwise rotation will decrease the distance.
4. Tighten the lockplate (A) after desired adjustment.
Top link implement end has provision for mounting
CAT-I & CAT-II implements.
Draft Sensing Bracket
Draft sensing bracket transfers the toplink force to the draft
sensing mechanism. It has three holes (B), (C) and (D) for
hitching the toplink.
Maximum achievable depth of implement increases as the
toplink is shifted from top to lower holes.
Top Hole (B) : Attach toplink to hole (B) where draft
sensing function is not required.
Centre Hole (C) : Attach toplink to hole (C) where medium
to Low draft sensitivity is required.
Lower Hole (D) : Attach toplink to hole (D) where very
high draft sensitivity is required.
Contact your Mahindra dealer to understand hitching
position of toplink for specific implements used by you.
Telescopic Lower Links
Telescopic Lower Links are provided for ease of hitching the
implement as follows,
1. Slowly back tractor into position to align the lower links
with implement pins.
2. Park tractor safely.
3. Press the bracket (E) in lower link and pull link (F) to
extend as needed.
4. Connect lower links to the implement. Sit on operator’s
seat and start engine.
5. Back tractor until each lock lever snaps and secures each
lower link in the lock position.
A
B
D
C
F
E
To Next Page
Loading...
Need help?
General