35 Series-HST, Model - 3535, 4035, 4535 & 5035
56
Pneumatic Tires
Adding Liquid Weight
It is acceptable to add liquid ballast to the tire / wheel
assembly on your Mahindra Tractors.
Consult your Local Tire Dealer or Manufacturer of Tires for
ballasting process.
Inflation
Keep tires properly inflated to the pressure as shown in the
Chart below. Under inflation will damage tire cord and may
cause the tire to slip on the rim and tear out the tube valve
stem. Over inflation results in excessive slippage, causing
rapid tire wear. Air pressure should be checked once a week
with an accurate low pressure gauge having one pound
graduations. Air pressure should not be allowed to drop or
exceed the recommendations.
Always see that the tire valve caps are in place and screwed
tight. The caps prevent loss of air through the valve core.
Further, they prevent debris from entering and damaging
the valve core and air chamber in the tires.
Exceptions (Rear Tires only)
When plowing with a moulded plow, the left hand or land
wheel should be inflated to 2 p.s.i. lesser than right hand
or furrow wheel.
Chart A-1
Tire Load Rating
Model Side Tire Size Tire Type Tire Capacity @ 25 mph Rolling Circum-
kg @ kg/cm
2
ference (mm)
Front 28 x 8.5 - 15, 6PR, TTL Industrial 1309 @ 3.17 2108
Rear 43 x 16 - 20, 4PR, TTL Industrial 1959 @ 0.59 3251
Front 12 x 16.5, 6PR, TTL Industrial 1918 @ 2.82 2489
Rear 16.9 x 24, 8PR, R4, TIT Industrial 2909 @ 1.26 3810
Front 9.5 x 16, 6PR, R1 HTL Ag 632 @ 1.41 2540
Rear 14.9 x 24, 6PR, R1 HTL Ag 1364 @ 0.79 3810
Front 14 x 17.5, 6PR, TTL Industrial 2191 @ 2.11 2718
Rear 19.5 x 24, 8PR, R4, TIT Industrial 3000 @ 1.10 3912
Front 9.5 x 20, 6PR, R1 HTL Ag 750 @ 2.11 2870.20
Rear 16.9 x 24, 6PR, R1 HTL Ag 1855 @ 0.94 3987.8
4035 /
4535
3535
5035
4035
To Next Page
Loading...
Need help?
General