VOLTAGE WARNING: Before connecting the tool to a power source (receptacle,
outlet, etc.) be sure the voltage supplied is the same as that specified on the
nameplate of the tool. A power source with voltage greater than that specified
for the tool can result
in
SERIOUS INJURY to the user
-
as well as damage to
the tool.
If
in
doubt, DO NOT PLUG IN THE TOOL. Using a power source
with
voltage less than the nameplate rating is harmful to the motor.
ADDITIONAL SAFETY RULES
1.
Avoid cutting nails. Inspect for and remove all nails from the workpiece before
2.
Don't cut hollow pipe.
3.
Do not cut oversize workpiece.
4.
Check for the proper clearance beneath the workpiece before cutting
so
that
5.
Always wear eye protection conforming with current national standard.
6.
Hold the tool firmly.
7.
Make sure cord is out of your way and not
in
the line of cut.
8.
Make sure the blade is not contacting the workpiece before the switch is
9.
Keep hands away from moving parts.
operation.
the blade will not strike the floor, workbench, etc.
Severe eye injury could result.
turned on.
.
IO.
When cutting through walls, floors or wherever "live" electrical wires may
be encountered, DO NOT TOUCH ANY METAL PARTS
OF
THE TOOL!
Hold the tool only by the insulated grasping surfaces to prevent electric shock
if you cut through a "live" wire.
11.
Do not leave the tool running. Operate the tool only when hand-held.
12.
Always switch off and wait for the blade to come to a complete stop before
13.
Do not touch the blade or the workpiece immediately after operation; they
removing the blade from the workpiece.
may be extremely hot and could
burn
your skin.
SAVE THESE INSTRUCTIONS.
4
,
To Next Page
Loading...
Need help?
General
