Makita ER2600L User Manual

18
(2) Air Induction System
(i) Air cleaner plate (including choke system)
(ii) Air cleaner cover
(iii) Air cleaner element
(3) Ignition System
(i) Spark Plugs.
(ii) Magneto or electronic ignition system.
(iii) Spark advance/retard system.
(4) Miscellaneous Items Used in Above Systems
(i) Hoses, Sealing gaskets, belts, connectors, and assemblies.
Makita USA, Inc will furnish with each new engine written instructions for the maintenance and use of the engine by the owner.
(e) MAINTENANCE STATEMENTS
It is your responsibility to have all scheduled inspection and maintenance services performed at the times recommended in the 2014 and
later Owner’s Manual and to retain proof that inspection and maintenance services are performed at the times when recommended. Makita
USA, Inc will not deny a warranty claim solely because you have no record of maintenance; however, Makita USA, Inc may deny a warranty
claim if your failure to perform required maintenance resulted in the failure of warranted part. The proof, which you maintain, should be given
to each subsequent owner of the engine. You are responsible for performing the scheduled maintenance described below based on the
procedures specied in the 2014 and later Owner’s Manual. The scheduled maintenance below is based on the normal engine-operating
schedule.
PROCEDURE INTERVAL
1) Clean engine and check bolts and nuts. Retighten if
necessary.
: Every 8 hours (daily)
2) Check and rell engine oil (4 stroke engine only) : Every 8 hours (rell daily up to upper limit)
3) Change engine oil (4 stroke engine only) : Initial 20 hours and every 50 hours afterward
4) Check clogging of cooling air passage and cylinder
ns. Remove and clean if necessary.
: Every 8 hours (daily)
5) Clean air cleaner. : Every 8 hours (daily)
6) Check spark plug. Clean and adjust if necessary. : Every 8 hours (daily)
7) Check mufer exhaust outlet (or port). Clean if
necessary.
: Every 50 hours (monthly)
8) Check fuel lter. If clogged, replace with new one. : Every 50 hours (monthly)
9) Adjust valve clearance, if applicable (4 stroke
engine only).
: Every 200 hours (yearly)
10) Replace fuel lines. : Every 200 hours (yearly)
11) Clean and inspect the complete engine. Replace
any damaged or worn out parts.
: Every 200 hours
12) Replace packings and gaskets with new ones. : Every reassembling

Makita ER2600L Specifications

General

Blade size	- mm
Blade type	Double blade
Product color	Black, Blue
Fuel tank capacity	0.6 L
Engine displacement	25.7 cm³
Engine power	830 W
Power source	Gasoline

Weight and Dimensions

Depth	1645 mm
Width	220 mm
Height	510 mm
Weight	4300 g